Copyright © 2011 Segway Inc. All rights reserved.20076-00001ac
2
Replace Battery Packs in Pairs
Whenever you replace a Battery Pack, consider replacing both Battery Packs. Replacing only one Battery Pack will not
necessarily increase the performance or range of your Segway PT, because the Segway PT is designed to operate only at
the level allowed by the lower-energy Battery Pack. Redundancy is a critical safety feature built into the Segway PT. This
applies to the Battery Packs. Therefore, you should replace Battery Packs in pairs (except in the unusual situation where a
Battery Pack is replaced because of damage or defect and the other Battery Pack is relatively new).
Use the Same Battery Pack Types
Your Segway PT is powered by two Li-ion or two NiMH rechargeable Battery Packs. The p Series model can only use two
48-cell NiMH Battery Packs. The i Series model uses either two 60-cell NiMH or two Li-ion Battery Packs. The XT, GT,
i2, and x2 models use two Li-ion Battery Packs. Do not mix Battery Pack types. Always use Battery Packs in pairs of the
same chemistry, for example, two NiMH or two Li-ion Battery Packs.
Lithium-ion Battery Pack Specifications
Charging Time
before first use: 12 hours
recharge from empty ~8 hours
Temperature Ranges
operating: 32° F – 122° F (0° – 50° C)
charging: 50° F – 122° F (10° – 50° C)
storage and transport: -4° F – 122° F (-20° C – 50° C)
General
capacity (Ah) and voltage: 5.2 Ah, 73.6 volts
dimensions: 14 x 7.5 x 3.2 in (35.7 x 19 x 8.2 cm)
battery pack weight (pair): 22.7 lbs (10.3 kg)
Compatibility
All i2 and x2 Segway PT models (that were shipped from the factory after October 12, 2006) are compatible with the
Li-ion Battery Packs. Segway PT software version 14.0 or later is required for Li-ion Battery Packs. If you own a Segway PT
model i180, XT, or GT, you already have version 14.0 software or higher and your Li-ion Battery Packs are “plug and play.”
An upgrade to the Segway PT software is necessary in order to use Li-ion Battery Packs with older Segway PT models
(Li-ion Battery Packs are not compatible with p Series models). To identify the software version on your i167, i170, i180, or
e167 PT, first, power on, then power down while observing the display. If you see any of the images below, your Segway PT
is compatible with Li-ion Battery Packs.
Software version 14.0 Software version 14.1
Software version 14.2
(2 Seiten)
(1 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern